|Producto anterior||Producto siguiente|
TREAD ROLLERS: 2.5" dia. x 11 ga. steel, model 251S.
PRESSURE ROLLERS: 1.9" dia. x 16 ga. steel, model 196S; 27" BF for all widths.
BELTING: 12" wide black PVC-120.COS.
SIDE MOUNT END DRIVE: Allows one direction unit operation.
DRIVE PULLEY: 12" dia., with 1-15/16" dia. shaft, crowned and fully lagged.
TAIL PULLEY: 8" dia. with 1-3/16" dia. shaft, crowned.
RETURN ROLLERS: 1.9" dia. x 16 ga. steel, model 196S, adjustable.
BED: 5 " x 1-1/2" x 3/16" formed steel channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.
BEARINGS: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.
SPEED: 35 FPM, constant.
ACCUMULATION: 5'-0" long zones with zone singulation operation. 1'-6" of live roller over end plates at each end of conveyor remains "live" during operation (# of zones x zone length + 3"-0" + overall conveyor length). Zones are pneumatically actuated by using photo electric sensors.
FRL: Unit is provided with filter, regulator, lubricator with 3/8 " ports for 60 PSI operational pressure.
FLOOR SUPPORTS: Optional
MOTOR DRIVE: 1 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: No. 60 chain provided at drive pulley. Chain take-up provided on motor base.
ELECTRICAL CONTROLS: Optional