Producto anterior Producto siguiente

138 Live Roller Conveyor Curve Light Duty Spur


138LRCS Conveyor

SPECIFICATIONS

TREAD ROLLERS: 1.9" dia. to 1-3/8" dia. x 16 ga. tapered rollers, model 138T; 1-3/8" dia. x 18 ga., model 138G w/ 5/16" hex, galvanized straight tangent rollers.

ROLLER CENTERS: 1-9/16" measured at inside radius of unit.

PRESSURE SHEAVES: Provides drive belt pressure to upper tread rollers.

BELTING: "B" section V-belt.


TAKE-UP: Screw type adjustable sheave with flat idler sheaves to maintain belt tension.

TANGENTS: 12" both ends on 60/30 degree unit; 18" both ends on 45/45 degree unit.

 

BED: 6" x 1-1/2" x 12 ga. formed steel channel frame.

 

BEARINGS: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.


ROLLER CHAIN: Drive shaft is driven by No. 50 chain.

 

FLOOR SUPPORTS: Optional


MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located under tangent straight section bed

DRIVE LOCATION: Drive located on outside of curve. Specify left hand tangent length, right hand tangent length and drive location ("left hand drive" or "right hand drive"). NOTE: Drive hand determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.

CAPACITY: 300 lb. total distributed live load.

 

SPEED: 60 FPM, constant

Etiquetado como