|Producto anterior||Producto siguiente|
TREAD ROLLERS: 2-1/2" dia. to 1-11/16" dia. x 14 ga. steel tapered rollers, model 254T; 1.9" dia. x 16 ga. steel straight tangent rollers, model 196S.
PRESSURE SHEAVES: Provides drive belt pressure to upper tread rollers.
BELTING: "B" section V-belt.
TAKE-UP: Screw type adjustable sheave with flat idler sheaves to maintain belt tension.
TANGENTS: 12" opposite spur end on 60/30 unit; 18" opposite spur end on 45/45 unit.
SPEED: 60 FPM, constant.
BED: 7" x 1-1/2" x 12 ga. formed steel channel frame.
BEARINGS: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.
ROLLER CHAIN:Drive shaft is driven by No. 50 chain.
FLOOR SUPPORTS: Optional
DRIVE LOCATION: Drive located on outside of curve. Specify left hand tangent length, right hand tangent length and drive location ("left hand drive" or "right hand drive"). NOTE: Drive hand determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.
CAPACITY: 500 lb. total distributed live load.
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed.
ELECTRICAL CONTROLS: Optional